Bright LED display that is easier to read than LCD display digital gauges. Programmable alarm output when pressure is out of the preset value. Adjustable display brightness that can be synchronized with headlight.
This digital boost gauge cam measure the manifold absolute pressure up to 3 bars. It can be set to display pressure in Bar or PSI unit. The recall function allow user to check the maximum or the minimum pressure and its occurrence time after run. The meter has a programmable alarm that can be set as high limit or low limit alarm.
The alarm is displayed on the front panel with bright red LED that is very noticeable. The alarm signal can also be sent out from the built-in relay. It can turn on a buzzer or other device.
The LED brightness can be synchronized with headlight. When the headlight turned on in the night, the display will be dimmed by the illumination signal. It can also be dimmed directly from the key pad. The meter is supplied with high precision 3 Bar electronic MAP sender as shown in the picture below.
The connector of the sender has 2 meters (6.5ft) of automotive grade cable installed. We are not liable for any damages caused due to improper use or abuse. Note: The gauge can only work with one sensor at a time. You may use an external mechanical switch to make it work with multiple sensors of the same type. It is not practical to switch two different types of sensor while you are driving because you need about 10 seconds to change input settings of the gauge.(It might be as short as one week when lucky, but that is not the general case). For South Europe, Russia, Asia: Central region of Canada: 3-4 weeks. For Middle East, Central and South America 5-6 weeks.
The item "DIGITAL Boost Gauge, MAP Sensor, 3 bar/45 PSI, Green" is in sale since Wednesday, February 02, 2011. This item is in the category "eBay Motors\Parts & Accessories\Car Electronics\12-Volt Portable Appliances". The seller is "auberinstruments" and is located in Alpharetta, Georgia.This item can be shipped worldwide.