The terminals are male 0.250 or 6mm style crimp terminals. The socket mounts into a 1-1/8 hole.It is rated a 15 amps at 12 volts. The fuse holder has a 16 ga wire loop 8 and a tight fitting cap to cover the 15 amp fuse. The plug is a standard 12 volt hot pop out lighter plug used for lighting cigarettes.
Quantity discounts available upon request. Add a socket boot to increase the weather resistance of the socket.The boot covers the the wire contacts and has an exit for the wires. For a straight boot (shown above but not included in this listing) see this listing. For a right angle boot for tight installations see this listing 110791911918.
Free assembly and installation instructions at this listing 120827257353 may be copied for free or sent to you.. This will help you install you socket assembly and attach to your battery. Add a USB charger adapter and universal USB connector waterproof vinyl boot. The adapter plugs into your socket to allow you to plug in your USB charger, and the boot slides over your USB cable connector to protect the connection from water intrusion and failure.
Add a vinyl plug boot to make the plug socket combination more waterproof. When using a 12 volt plug and socket combination outdoors, there is a gap between the socket and the plug that is susceptible to water entry. The plug boot slides over any cigarette lighter plug or accessory plug.
When the plug is inserted into the power outlet / socket, the boot presses up against the socket surface and forms a seal. No more blown fuses or intermittent operation. UPGRADE option for your socket cap / lid/ cover for extreme weather or high vibration conditions. You will receive the socket cap that will have a metal insert installed that allows the cap to fit tightly in the socket for severe and harsh conditions. Add a high quality smart 12 volt trickle charger that plugs into your socket.
It will keep your battery a full charge when it is not in use. The charger plugs into the wall and has a 10 ft cord with a 12 volt lighter style plug with a weather proof boot. You can charge your battery outside. Add a rubber occlusive sealing socket washer.
Makes an extra waterproof seal when mounting the socket against a panel. The washer goes between the socket flange or nut, and the panel to seal the assembly. Add wires with a fused 60 inch (5ft) wire harness to your socket assembly.
The harness comes with of a fuse holder and fuse, and red and black wire connectors to attach to your socket and battery. Just return it for repair or replace. Add a socket switch waterproof-Single pole single throw (SPST). Rubber switch cover and sealed back fits in a socket hole. Add a mounting hole bore.Allows you to drill or enlarge a hole in your panel or dash to mount this product. Add a custom label or marker.
A label frame fits around the front flange face and allows you insert a labeled tag. Allows for mounting this product either under or over a surface or dashboard. The item "Cigarette Lighter 12 Volt Motorcycle Marine Socket Power Outlet & Fuse & Plug" is in sale since Monday, February 11, 2013. This item is in the category "eBay Motors\Parts & Accessories\Car Electronics\12-Volt Portable Appliances".
The seller is "andy14nq" and is located in Carmel, California. This item can be shipped worldwide.