3.4 cu ft LP Gas 3-Way Refrigerator Compact Fridge Freezer Propane Mini Cooler. 3.4 cu ft (95 L). 3.0 cu ft (85 L). 0.4 cu ft (10 L). 20.823.232.5 inch.
Gas Flame Failure safety valve. This is a 3.4 cu ft (95 Liters) 3-way fridge freezer, can use LP Gas (Propane), 110V (Electricity) and 12V DC. Has power switch function, gas safety value, portable handle. For best performance at high ambient temperatures, there must be free air circulation over the cooling unit at the rear of the refrigerator.
Minimum clearances to combustible materials are: Top 4. The refrigerator must be adjusted to a vertical position in both directions. Absorption refrigeration system, ammonia is liquefied in the finned condenser coil at the top rear of the refrigerator.
The liquid ammonia then flows into the Evaporator inside. The fridge section and is exposed to circulating flow of hydrogen gas, which causes the ammonia to evaporate, creating a cold condition in the fridge. When starting this refrigerator, the cooling cycle may require 6 to 10 hours of running time to begin cooling before the cooling unit is fully operational, you can then begin slowly loading the compartment. Prepare the propane tank yourself, we have two kinds regulator available now, the one with red cap can adjust the PSI. Below are the links for your reference.
Make sure that all valves between the gas container and the refrigerator are open. Turn selector switch (A) to gas. Depress the safety device control (D) and hold it down while immediately depressing the electronic igniter button (B). Once the flame indicator (C) starts to move into the green, release the electronic igniter button (B) but continue to keep the safety device control (D) depressed for a further 10-15 seconds.Release the safety device control (D) and again check to see that the flame is alight, making sure the needle is in the green area of the flame indicator. Adjust the thermostat knob (E) to desired temperature setting and allow for 6 to 8 hours of operation to achieve desired temperature. Shut Down Procedure LP Gas. To terminate gas operation, turn selector switch (A) to either OFF or AC (110V) position. Shut the gas off at the LP-gas supply cylinder when the appliance is not in use. If the refrigerator will not be in operation for a period of weeks, it should be emptied, defrosted, cleaned and the doors left open. The ice tray should also be dried and kept outside the cabinet. Make sure that the gas valve is turned off at the tank. Ensure the electrical cord is plugged into a grounded outlet.
Turn the selector switch (A) to AC (110V) position. Adjust the thermostat knob (E) to desired temperature setting and allow for 6 to 10 hours of operation to achieve desired temperature. If 110 Volts or LP gas is not available, the refrigerator can work with DC 12V.
Make sure that you turn the main power switch (A) to AC (110V) position. This will allow the heating element to work, you can then connect the 12VDC power cord (not supplied) to the terminal block located at the upper right side of the refrigerator, while facing the back. DC operation is not as efficient as LP Gas or AC operation.DC electric should not be used to initially cool the refrigerator. Only use DC when the other modes are unavailable (for example; while in transit). When you start to use AC or gas supply, make sure that you disconnect the DC power input.
To terminate any power mode, gas, AC or DC, turn the knob (A) to either of two OFF positions. Battery replacement for electronic spark ignition. Hold and pull down the A as illustrated in pic, take out the battery box. Replace the old AAA battery B with new one. Note: 7#1.5V battery need to be used and the red wire must connect to the + side of the battery.
Door Removal & Reversal Instructions. This appliance has the capability of either opening the door from the left or right side.
The unit is delivered to you with the door opening from the left side, to the right. Should you desire to reverse the opening direction, please follow instructions below. Lay the fridge on one side exposing the bottom of the fridge, suggested. Remove the lower hinge (D) by loosening and removing all the screws with. Carefully pull away the door from top pin (E) and set aside.Remove the top hinge pin (F) with a slotted screwdriver and move it to the opposite side (G). Turn fridge upside down and proceed to slide the top of the freezer door onto the top hinge pin. Insert the lower hinge into the bottom hole of the fridge door, also including any round spacers that may have been present on the hinge pin when you. Line up the side of the fridge door with the cabinet. Before tightening hinge to bottom of cabinet.
Start to fasten the lower hinge to the bottom of the appliance. Tighten all screws once youre sure. Some screws will be self-tapped in bottom of. The door handle (C) can be mounted to the other side of the door.
If there is a gap between the cabinet and the door gasket, set the gasket by gently pulling it out to seal the gap. If necessary, you are recommended also to use the hair dryer to warm the gasket in hot water to get rid of the gap.When your order arrives and there is no issue, please leave 5 star feedback to notify us that you have received your item. Buyers satisfaction is top priority. Issues can be effectively addressed through simple communication. You don't need to start a return request. We are always at your service. Your satisfaction is our motivation! The item "3.4 cu ft LP Gas 3-Way Refrigerator Compact Fridge Freezer Propane Mini Cooler" is in sale since Tuesday, June 20, 2017. This item is in the category "Home & Garden\Major Appliances\Refrigerators & Freezers\Refrigerators". The seller is "smad_01" and is located in Ontario, California. This item can be shipped to United States.